[Opensim-dev] config changes for HG

[Marck]

Hello Ai,

For hypergrid setups, you should use Robust.HG.ini.example instead of Robust.ini.example as a basis. The former has all the connectors that are necessary for HG and also the Check4096 option.


Ai Austin wrote:
>
>> From: Diva Canto <<mailto:diva at metaverseink.com>diva at metaverseink.com>
>>
>> Bugs ==> mantis ==> thanks!
>
>
> Hi Diva... I am back after a long trip away and catching up with
> progress on 0.7.1 Dev master Branch. Unless you advise against it just
> now I would be happy to set up a new version based on the latest Master
> 0.7.1 Dev Master (r/14611 as at 6-Dec-2010) and see how we get on in the
> Openvue Grid using the new setup. I will take care to use the new
> example config files as a basis for the new Robust.ini, OpenSim.ini and
> add-config/GridCommon.ini
>
> I am working on Robust.ini just now and note a few things... before I
> try to execute the new setup it would be helpful if you could warn me if
> any of these items need attention...
>
> a) [Startup] section. The number of connectors now is quite a bit less
> than previously. I assume that's fine?
>
> b) [GridService] section. The parameter for Check4096 = "True" is no
> longer there. Is that an omission?
>
> c) [FreeSwitch] section. After setting our FS server IP which is NOT on
> the same host as the Robust services... should the commented out entries
> that are 127.0.0.1 after that just be left commented out and the correct
> IP asset will be used. Or should they be explicitly uncommented and set
> to the actual FreeSwitch IP. I have assumed this latter option is
> required. But it would be good to know, as it was this sort of
> uncertainty that confused many trying to set up FreeSwitch before.
>
>
> Working on OpenSim.ini next, so I may have a question or two on that
> too. But that should not be related to the new HG changes.