[Opensim-users] large terrains

[Paul Fishwick]

I played with large terrains a while back, and wanted to get back into 
it,with
the discussion of megaterrains. After much searching through the web and
docs, my results are getting only one region filled. Here are the 
parameters:

1) 2 x 2 region with the southwest at 1000,1000 and the northeast at 
1001,1001
2) used L3DT to generate a nice heightfield with a floor of 0 and 
terrain no higher than 60
3) this heightmap is 512x512 in resolution
4) exported the heightmap to an R32 format and called it test.r32
5) inside of the console after a change-region to the southwest 
(1000,1000) region,

    terrain load-tile test.r32 2 2 1000 1000

    loads only region 1 @ 1000,1000

    the other 3 regions are as they were

Anyone else experienced this?

-p

-- 
Paul Fishwick, PhD
Professor and Director, Digital Arts and Sciences Programs
University of Florida
Computer & Information Science and Eng. Dept.
Bldg. CSE, Room 301
P.O. Box 116120
Gainesville, FL 32611
Email: fishwick at cise.ufl.edu
Phone: (352) 392-1414
Fax: (352) 392-1220
Web: http://www.cise.ufl.edu/~fishwick