[Opensim-dev] Cleaned up freeswitch voice instructions

[Melanie]

You're wrong. Avination has used Freeswitch voice using the ROBUST
service in grid mode before switching to Vivox. It is fully
implemented and working.

I respectfully ask to remove your misleading warning yourself.

Best regards,

Melanie

On 27/09/2011 00:20, Justin Clark-Casey wrote:
> fyi, today I did some work on the freeswitch voice wiki page [1], clarifying some of the instructions and adding a new 
> section on how to actually start up the various bits and what kind of thing you should expect to see in the log.
> 
> I followed these instructions through to get my Freeswitch setup working again under OpenSim 0.7.2-rc2 on a single 
> region standalone.  Both viewer 1 and viewer 2/3 appear to be working on standalone.  Even under Freeswitch, Viewer 2/3 
> voice quality seems much better than 1, or perhaps the default is just louder.
> 
> Unfortunately, I also confirmed the fact that Freeswitch voice for an entire grid is not implemented, and that the 
> instructions are misleading on that score.  I put a warning on the top of the page rather than change it completely. 
> since the grid option will hopefully be implemnted some time in the future.
> 
> However, Ai's section at the bottom suggests that even without the ability to run the Freeswitch service component as a 
> ROBUST grid service, it's still possible to adjust the config in such a way that voice covers an entire grid.  However, 
> I don't currently have the opportunity to try or elaborate on this.
> 
> [1] http://opensimulator.org/wiki/Freeswitch_Module
>