LLUDP ClientStack - Revision history

Manni at 12:01, 4 December 2023

2023-12-04T12:01:18Z

2023-01-11T13:02:52Z

‎Useful console commands: debug lludp commands no longer available.

2016-04-23T13:53:15Z

2014-11-26T01:46:04Z

‎Throttles

2014-11-26T01:44:05Z

‎Throttles

2014-11-26T01:38:28Z

‎Settings

2014-11-26T01:37:53Z

‎Settings

2014-11-19T01:24:21Z

‎Inbound UDP

2014-11-18T21:07:30Z

‎Throttles

2014-10-06T21:55:02Z

‎Throttles

← Older revision		Revision as of 12:01, 4 December 2023
Line 1:		Line 1:
−	{{~~MainPageQuicklinks~~}}	+	{{Quicklinks\|LLUDP_ClientStack}}

	=Introduction=		=Introduction=

← Older revision		Revision as of 13:02, 11 January 2023
Line 18:		Line 18:

	=Useful console commands=		=Useful console commands=
		+
		+	Note these console commands are no longer available in OpenSimulator. The description below is left in place for historical information.

	These are console commands which are useful in debugging or investigating the LLUDP protocol.		These are console commands which are useful in debugging or investigating the LLUDP protocol.

@@ Line 69: / Line 69: @@
 == Throttles ==
-'''This section is incomplete, though there is an old informal discussion of throttles at [[Sim Throttles]].'''
+'''There is also an old informal discussion of throttles at [[Sim Throttles]] which may or may not be accurate.'''
 Outbound UDP is throttled per client, with an optional throttle for the entire scene.

@@ Line 69: / Line 69: @@
 == Throttles ==
-'''This section is very incomplete, though there is an old informal discussion of throttles at [[Sim Throttles]].'''
+'''This section is incomplete, though there is an old informal discussion of throttles at [[Sim Throttles]].'''
 Outbound UDP is throttled per client, with an optional throttle for the entire scene.

@@ Line 91: / Line 91: @@
 </source>
-Then throttles are set by the client.  Throttle rates may still be restricted on the server side by setting either or both of
+Then throttles are set by the client.
 <source lang="ini">

@@ Line 82: / Line 82: @@
 </source>
-(the current default).  Then client throttles are adjusted automatically by the server.  Whilst the connection is fine, rates are increased.  However, if packets marked as reliable are not received in a timely manner, then the throttle is reduced until no more packets are losed.
+(the current default).  Then client throttles are adjusted automatically by the server.  Whilst the connection is fine, rates are increased.  However, if packets marked as reliable are not received in a timely manner, then the throttle is reduced until no more packets are lost.  The throttle is then gradually increased again until either the throttle requested by the client is reached or more packets are lost.
 If

← Older revision		Revision as of 01:24, 19 November 2014
Line 26:		Line 26:

	=Inbound UDP=		=Inbound UDP=
−
−	~~TODO: Need to fill out more as required.~~

	== Code paths ==		== Code paths ==